Wednesday

EX_03 Trial and Error

Basically right now I am just trying to figure out the best way to approach putting a structural frame onto this form. I know the design I want to accomplish but not sure how to get there yet.
Here I drew 2 curves on the surface of the form and tried to create an average of the two lines between them and got a very awkward curve as a result.

Here the projection of the the lattice design did not completely enclose the surface I was trying to cover.

The paneling tool creates great surfaces but I need a frame.

Here is the beginning of a series of ribs on a platform which could then be connected by secondary framing.




No comments:

Post a Comment